It is typically recommended to apply the adhesive to the center of the bottom surface, the slowly bring down the top surface and then use small lateral movements to spread it. This Application Note is intended to guide users of Luna's High Definition Fiber Optic Sensing (HD-FOS) system (the ODiSI) through the simple process of mounting a fiber sensor onto the surface of a test article. The process of mounting the fiber optic strain sensor is very similar to the process. Fiber optic sensing (FOS) systems can provide high-fidelity distributed strain measurements in various industries such as aerospace, automotive, structural health monitoring, and civil engineering. Each has their own specific. I've got a HAT board with five status LEDs I'd like to get somehow extended to the front panel of my system, so that I can read its status without opening the enclosure. the five white rectangles you can see on the picture near the bottom edge of the board are the LEDs: The almost obvious solution. This video demonstrates the process of installing a fiber optic sensor to a substrate for measuring distributed mechanical strain. Bonding fiber optic cables and components isn't like sticking two pieces of.
